Aspire Odan Coil Heads (Pack 3x)
3 x Aspire Odan Coil Heads
The Odan atomizer heads from Aspire are suitable for the following atomizers:
- Aspire Odan vaporizer
- Aspire Odan Mini Vaporizer
The Odan Mesh Heads are intended for use in the Aspire Odan Tank atomizer of the same name. In the Aspire Mesh Heads, no pure cotton was used as the carrier material, but a mixture of 80% linen and 20% cotton. This should ensure an even distribution of the liquid and thus have a positive influence on the liquid flow. The mesh heads have a low resistance of 0.18ohm, 0.2ohm and 0.3ohm. Due to the low resistance, the heads are designed for vaping with direct lung puffs. Please note that atomizer heads are wearing parts and should therefore be replaced regularly.
Aspire Odan Coil 0.3ohm:
- Screen coil/mesh coil - one winding - designed for direct lung pulls (DL)
- A winding is built into these coils and a bent and perforated wire mesh is used for the winding.
- The atomizer heads are optimized for a power of 35W - 45W.
Aspire Odan Coil 0.2ohm:
- 0.2ohm atomizer resistance
- Organic cotton
- 50 to 60W
- Single mesh coil
- friction fit
The 0.18 Ohm can be used between 60 - 80W
Important: When using a new evaporator head, please wait 5 minutes before using it for the first time so that the cotton can soak up the liquid.
When using atomizer heads with a resistance of less than 1.0 ohms, only rechargeable batteries that can deliver a high continuous load (>20 A) or are marked as suitable for sub-ohms may be used.