Innokin Endura Prism S / T20S Coil Heads (Pack 5x)
5 x Innokin Prism atomizer heads T20-S
Matching Innokin atomizer heads for the Prism T20-S atomizer, as it is also included in the Endura T20-S set or EZ.Watt kit. The prefabricated coils are not suitable for the Prism T18, Prism T20 and T22 evaporators, you can also find the right coils for these evaporators in our shop.
In contrast to the T20 atomizer heads, the main focus in the development of the S Coils was, according to the manufacturer, on even better taste and an optimal flash in the throat. In addition, the Prism S atomizer heads are not only offered with 1.5 ohms, but also with a resistance of 0.8 ohms.
The prefabricated coils were specially developed for the Prism T20-S, the atomizer heads of the various Prism atomizers from Innokin are not compatible with each other!
The Prism T20-S coils are designed for back steamers that inhale the steam first into the mouth and then to the lungs (ML / MTL = Mouth to Lung). The resistances of 0.8 ohms or 1.5 ohms ensure a pleasant development of steam. According to the manufacturer, the new development ensures a good flow rate even with a high VG proportion of the liquid.
- 0.8 ohm: The evaporator heads are optimized for outputs from 16 to 18W and are ideally suited for jaw pulls (MTL). They can only be operated in VW mode.
- 1.5 ohms: The evaporator heads are optimized for outputs from 13 to 14W and are ideally suited for jaw pulls (MTL). They can only be operated in VW mode.
Important: When using a new atomizer head, please wait 5 minutes before using it for the first time so that the cotton can soak up the liquid.
Changing the evaporator head (see drawing):
Unscrew the base from the tank housing and remove the atomizer head by pulling it out of the base.
Now take a new atomizer head and push it into the atomizer from below. Now screw the base and tank housing back together.
When using atomizer heads with less than 1.0 ohm resistance, only batteries that can deliver a high continuous load (> 20 A) or are marked as sub-ohm-compatible may be used.